Removing the spring strut holder on left and right
NOTE:
Perform the steps on the right and left side.
Removing the spring strut holder
- Loosen nut (1).
- Punch in the swivel bearing (2) at the front towards the inner.
- Pull out screw (3).
Marking the installation position of the spring strut holder
- Mark the installation position of the spring strut holder (1) for the spring strut (2) before the removal.
- A color coding (3) must be made in the edge extension (4).
- Release the screw (1) from the spring strut holder (2).
- Expand spring strut holder (1) with special tool 2 414 636 .
NOTE:
RISK OF DAMAGE
Failure to comply with the specification.
Component damage.
Failure to comply with the specification.
Component damage.
- All specifications must be observed and complied with.
- Protecting the output shaft from damage with a towel is mandatory (1).
- Release swivel bearing (2) from the attachment on the upper wishbone.
- Guide out and remove spring strut holder (3) downwards in the arrow direction.
Secure the swivel bearing
- Fasten the swivel bearing (1) by using the special tool 2 413 317
to protect it from tilting outwards.
Swivel bearing (1) must not hang down from the brake hose.