Installing the left and right crash lever
NOTE:
Perform the steps on the right and left side.
Installing crash lever
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
NOTE:
TECHNICAL INFORMATION
Do not mix up the left and right.
Do not mix up the left and right.
- Position the crash lever (3) .
- Replace screws (1)
and (2)
.
Parts: Screws
- Tighten down screws (1) and (2) .
TIGHTENING TORQUES SPECIFICATION
| Crash lever to front subframe/frame | ||
|---|---|---|
| M12 Replace screw. |
Tightening torque | 68 Nm |