Install front bumper cover

• Position the front bumper cover (2) and engage it in the detents in the area of the dotted line.
• Tighten down screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Upper bumper cover on air flap control
  screw	Tightening torque	3 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: Perform the steps on the left and right side.
• Clip the front bumper cover (2) upwards into the detents.
• Tighten down screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Front bumper cover on side wall
  Hexagon screw	Tightening torque	3 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect and lock the plug (1) into the left wheel well.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect and lock the plug (1) into the right wheel well.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Under shield/frame
  Hexagon screw	tightening torque	3 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to PARTIALLY INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
• Refer to PARTIALLY INSTALLING THE LEFT FRONT AND RIGHT WHEEL ARCH TRIM .
• Refer to INSTALLING FRONT ORNAMENTAL GRILLE .