Releasing the electric coolant pump and coolant hoses from the front axle support
- Release the coolant hose (1) from holders (2) on front subframe.NOTE: The following step(s) must be performed if the specified component(s) is/are installed.
- Release the screws (1) from the holder for the electric coolant pump (2).
- Position the holder for the electric coolant pump (1) above the stabilizer (2).
- Release the screws (1) from the holder for the electric coolant pump (2).
- Position the holder for the electric coolant pump (1) above the anti-roll bar (2).
- Release the coolant hoses (1) from the holders (2) from the front axle support.
- Release the holder (1) on the right side on the front axle support (2).