Fasten electric coolant pump and coolant hoses to the front axle support

• Fasten holder (1) to the right hand side of the front axle support (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Fasten coolant hose (1) on the brackets (2) on the front axle support.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the holder for the electric coolant pump (2) on the front axle support (2).
• Tighten the screws (1).

TIGHTENING TORQUES SPECIFICATION

Holder to front axle support
M6 Replace screw.	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

• Secure coolant hose (1) on the holders (2) at the front subframe.

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: The following step(s) must be performed if the specified component(s) is/are installed.
• Position the holder for the electric coolant pump (2) on the front subframe (2).
• Tighten down screws (1).

TIGHTENING TORQUES SPECIFICATION

Holder to front axle support
M6 Replace screw.	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.