Installing the reinforcement on the left and right bumper cover
NOTE:
Description is for left component only. Procedure on the right side is identical.
Installing the reinforcement on the bumper cover
- Place the reinforcement (3) and engage it into the detents (arrows).
- Install the expanding rivet (1).
- Tighten down screw (2).
TIGHTENING TORQUES SPECIFICATION
| Bumper bracket, side front | ||
|---|---|---|
| screw | Tightening torque | 3 Nm |
- Connect connectors (1) and lock.
- Secure the wiring harness (2) to the holders (arrows).