Installing the engine on the assembly jig
- Position the assembly jig 0 495 187 (00 2 300)
with the special tool 0 495 196 (00 2 320)
.
- Tighten the screws (arrows).
TIGHTENING TORQUES SPECIFICATION
| Special tool 00 2 320 to special tool 00 2 300 | ||
|---|---|---|
| M14X95 | Tightening torque | 130 Nm |
- Screw special tool 0 496 926 (11 9 030) together with special tool 0 495 196 (00 2 320) .
TIGHTENING TORQUES SPECIFICATION
| Special tool 2 413 082 to special tool 00 2 320 | ||
|---|---|---|
| M12x65 | Tightening torque | 100 Nm |
- Prepare special tool 2 288 357 together with the special tool 0 496 926 (11 9 030) .
- Lift the engine with workshop crane onto the assembly stand.
- Screw special tool 0 496 926 (11 9 030) and special tool 2 288 357 together with the engine.
TIGHTENING TORQUES SPECIFICATION
| Special tool/holder to crankcase | ||
|---|---|---|
| M10x35 | Tightening torque | 40 Nm |
- Position the engine with a workshop crane (1) and the special tool 0 490 567 (11 0 020)
on the special tool 2 413 082
.
- Make sure that the engine is correctly engaged using the special tool 2 411 718 on the special tool 2 413 082 .
- Tighten the nuts (1) of the special tool 2 413 082 , until the clamping jaws fit completely on the special tool 2 411 718 .