Installing fuel delivery line
- Slide the fuel supply line in the direction of the arrow into the snap fastener (2)
and lock.
The fuel supply line must be audibly engage in the snap fastener (2) .
- Secure the clamp (1) .
- Tighten down screw (3)
.TIGHTENING TORQUE SPECIFICATIONS
Fuel line to cylinder head cover 6x18 tightening torque 7 Nm - Guide the fuel delivery line (2) in and install.
- Install rubber damper (3) .
- Make sure the rubber damper (3) is fitted correct.
- Tighten the union nut (1) hand-tight.
- Tighten union nut (1)
.TIGHTENING TORQUE SPECIFICATIONS
Feed line to high pressure pump M14X1.5 Tightening torque 26 Nm - Check fuel system for leak tightness.
Follow-up work
- Refer to INSTALLING THE IGNITION COILS .
- Refer to INSTALLING ACOUSTIC COVER AT REAR .
- Refer to INSTALLING THE COWL UPPER PART .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to INSTALLING THE REAR HOOD SEAL .
- Refer to ACTIVATING ELECTRICAL SYSTEM .