Install catalytic converter

Replace seal (1) on catalytic converter.
Parts: Gasket

Courtesy of BMW OF NORTH AMERICA, INC.
Replace the V-clip (1).
Parts: V-band clamp

Courtesy of BMW OF NORTH AMERICA, INC.
Feed in and install catalytic converter (3).
Feed in and install the new V-ribbon clip (2).
Hand-tighten the bolt (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Insert and install the holder (4).
Tighten down screws (3).

TIGHTENING TORQUE SPECIFICATIONS

Holder, catalytic conv. to transmission
M12x100	Tightening torque	66 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUE SPECIFICATIONS

Catalytic converter/Gasoline particulate filter to holder
M8x20/M8 nut Replace screw/nut.	Tightening torque	19 Nm

TIGHTENING TORQUE SPECIFICATIONS

Catalytic converter/Gasoline particulate filter to holder
M8x20/M8 nut Replace screw/nut.	Tightening torque	19 Nm

Feed in the positive battery cable (1) and attach to clamps (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten the screw (1) on the V-ribbon clip.

TIGHTENING TORQUE SPECIFICATIONS

Catalytic converter/gasoline particulate filter to exhaust turbocharger
V-band clamp Replace V-band clamp.	Tightening torque	13 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

If installed: Installing differential pressure sensor

Installing differential pressure sensor

TIGHTENING TORQUE SPECIFICATIONS

Differential pressure sensor to holder
hexagon nut M6	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Replace pressure hose (2)
Parts: Pressure hose
Push the pressure hose (2) onto the differential pressure sensor (4) in the arrow direction all the way to the stop.
Connect and lock the connector (1).
The connector (1) must engage audibly.

Follow-up work