Installing the transmission oil cooler
WARNING:
Hot fluids.
Risk of scalding!
Risk of scalding!
- Conduct all work in the vehicle wearing appropriate personal protective equipment only.
CAUTION:
Materials harmful to health.
Contact with fluids harmful to health!
Contact with fluids harmful to health!
- Note and follow safety instructions on containers.
- Conduct all work in appropriate personal protective equipment only.
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Preliminary work
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION .
- Refer to REMOVING THE CENTER UNDERBODY PROTECTION .
- Refer to REMOVING REAR UNDERBODY PROTECTION .
- Refer to REMOVING THE FRONT RIGHT LOWER WHEEL ARCH COVER .
- Refer to DRAINING THE COOLANT FOR THE HIGH-TEMPERATURE COOLANT CIRCUIT .
- Feed in and install the transmission oil cooler (1).
- Tighten screw (2) by hand.
- Tighten screw (1) by hand.
- Tighten screw (2) by hand.
- Tighten down screw (1).TIGHTENING TORQUE SPECIFICATIONS
Transmission oil cooler to crankcase M6 Tightening torque 8 Nm - Tighten the screws (3).TIGHTENING TORQUE SPECIFICATIONS
Transmission oil cooler to crankcase M6 Tightening torque 8 Nm - Tighten the screws (2).TIGHTENING TORQUE SPECIFICATIONS
Transmission oil cooler to crankcase M6 Tightening torque 8 Nm - Secure clamps (1).
- Connect the transmission oil lines (2).
- Press the locking mechanism (1) in the arrow direction and lock the transmission oil lines (2).
- Connect and lock the coolant line (2).
Coolant line (2) must engage audibly.
- Connect and lock the coolant line (1).
Coolant line (1) must engage audibly.