Install tension strut on shock tower
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Install tension strut (3) on the shock tower.
- Replace the screw (1).
Parts: Screw
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Tension strut on firewall | ||
| M10x25 screw Replace screw. |
Joining torque | 56 Nm |
| Angle of rotation | 90° | |
- Replace the screw (2).
Parts: Screw
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATIONS
| Tension strut to shock tower | ||
| Torx bolt Replace screw. |
Joining torque | 56 Nm |
| Angle of rotation | 90° | |
Repairing the thread on the strut tower
- Repair the damaged thread with the Helicoil thread insert.
CONSUMABLE SPECIFICATIONS
| Helicoil thread insert | M10x25 mm | 33 30 6 782 756 |
Follow-up work
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .