Installing the alternator
- Slightly push back the threaded support sleeve (2) in the direction of the arrow to facilitate the installation of the alternator.
- Screw the screw (1) into the threaded support sleeve (2).
- Press back the threaded support sleeve (2) using the bolt (1).
- Once again unscrew the screw (1) from the threaded support sleeve (2).
- Insert and install the alternator (2).
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Alternator on component carrier | ||
| M10x75 | Tightening torque | 38 Nm |
| M10x125 | Tightening torque | 38 Nm |
| M10x90 | Tightening torque | 38 Nm |
- Tighten nut (1).
TIGHTENING TORQUE SPECIFICATIONS
| Positive battery cable to the alternator | ||
| M8 | Tightening torque | 19 Nm |
- Connect and lock the connector (2).
The connector (2) must engage audibly.
Follow-up work
- Refer to PREPARING THE THROTTLE BODY .
- Refer to INSTALLING THE THROTTLE BODY .
- Refer to INSTALLING THE DRIVE BELT FOR ALTERNATOR .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING MOUNT OF HOOD SEAL ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE COVER PANEL OF THE ENGINE COMPARTMENT ON THE REAR LEFT AND RIGHT .
- Refer to INSTALLING FRONT-END STRUT ON LEFT AND RIGHT .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to ACTIVATING ELECTRICAL SYSTEM .
- Refer to WHEN REPLACING THE ALTERNATOR/ALTERNATOR REGULATOR: RESET GENERATOR STATISTICAL DATA .