Remove the ornamental grille from the front bumper cover laterally

Preliminary work 

• Refer to REMOVING FRONT ORNAMENTAL GRILLE .
• Refer to PARTIALLY REMOVING THE LEFT AND FRONT RIGHT WHEEL ARCH TRIM .
• Refer to PARTIALLY REMOVING THE FRONT SECTIONS OF BOTH WHEEL ARCH COVERS AT THE FRONT .
• Refer to REMOVING FRONT BUMPER COVER .
• Refer to REMOVING THE FRONT TRIM STRIP .

• Unclip and remove cover (1) of the air inlet from the detents (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen screws (2).
• Loosen wiring harness from the clamp connections (1).
• Release and remove air duct (3) from the detents (4).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Disconnect the connector (1).
• Release and remove ornamental grille (2) from the detents (3).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Slightly spread the detents (1) and guide out the ultrasonic sensor (2).

Courtesy of BMW OF NORTH AMERICA, INC.