Installing the left and right ornamental grille on the front bumper cover on the side

NOTE: Description is for left component only. Procedure on the right side is identical.

Installing the ornamental grille on the front bumper cover on the side

Slightly spread apart the detents (1) and insert the ultrasonic sensor (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Clip ornamental grille (2) into detents (3).
Connect plug (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Clip air duct (3) into detents (4).
Clip vehicle wiring harness into clamp connections (1).
Tighten screws (2).

TIGHTENING TORQUE SPECIFICATIONS

Air duct to bumper cover
screw	Tightening torque	3 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Courtesy of BMW OF NORTH AMERICA, INC.