Remove output shaft
WARNING:
Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Observe safety instructions on raising the vehicle using a vehicle hoist.
- For additional information see: RAISING THE VEHICLE WITH A VEHICLE LIFT .
Preliminary work
- Refer to REMOVING THE FRONT LEFT WHEEL .
- Refer to REMOVING THE COVER OF THE STEERING ASSEMBLY .
- Refer to REMOVING THE CENTER UNDERBODY PROTECTION .
- Refer to RELEASING THE TIE ROD FROM THE SWIVEL BEARING .
- Refer to LOOSENING THE OUTPUT SHAFT FROM THE WHEEL BEARING .
- Refer to RELEASING THE WISHBONE FROM THE SWIVEL BEARING .
Remove output shaft
NOTE:
TECHNICAL INFORMATION
Secure component against falling.
Secure component against falling.
- Position the aluminum drift (2) on the output shaft (1).
- Knock out the output shaft (1) out of the front differential or the bearing bracket with the aluminum mandrel (2).
- Guide out the output shaft (1) in the arrow direction and remove.