Removing the oxygen sensor monitor
Oxygen sensor monitor
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
NOTE:
RISK OF DAMAGE
Damage to wires when disconnecting connectors and plug connections.
Sheared wires can cause a short circuit.
Damage to wires when disconnecting connectors and plug connections.
Sheared wires can cause a short circuit.
- Do not pull on wires when disconnecting connectors and plug connections.
NOTE:
The cable of the oxygen sensor monitor is gray. The installation location of the oxygen sensor monitor is behind the catalytic converter.
- Detach the cable (1) from the clamps (2).
- Unlock plug connection (1) and disconnect.
- Unlock the plug connection (1) with the screwdriver (2) and disconnect it and pull it off from the carrier plate.
- Release the oxygen sensor monitor (1) with the special tool 0 493 751 (11 9 150) .
- Remove the oxygen sensor monitor (1).