Removing the front output shafts (on the mobile lifting table)

NOTE: The following step(s) must be performed if the specified component(s) is/are installed.

• Remove the sealing cap (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen screws (1).
• Remove the swivel bearing mount (2) and set it aside.
• Hold the swivel bearing (3) with the workshop crane 2 220 718. 

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen screw (1).
• Tilt the swivel bearing (2) slightly forward in the arrow direction.
• Loosen and remove the output shaft (3) at the front axle differential with a suitable tool.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install the stand (1) of the swivel bearing.
• Tighten down screws (2).

Courtesy of BMW OF NORTH AMERICA, INC.