Removing rear door sill cover strip on left and right
NOTE:
The steps shown on one side must be performed on both sides.
Remove rear entrance cover strip
NOTE:
RISK OF DAMAGE
Bending of plastic components.
Application of too much force can lead to bending of plastic components.
Bending of plastic components.
Application of too much force can lead to bending of plastic components.
- Place special tool directly beside the mounting clip.
- Continue unclipping the part without using the tool if possible.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Release the rear seat (1) in area (2) in upward direction from the detents.
- Unfasten nut (1).
- Detach rear door sill cover strip (2) upwards from the clamps (3) and clips (4) using the special tool 0 496 569 (00 9 325) and remove it.