Installing both D-pillar trim panels

NOTE: Description is for left component only. Procedure on the right side is identical.

Installing D-pillar trim panel

Check the clamps (1) and clips (3) on the D-pillar trim panel (2) for damage, replace if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.
Fit the D-pillar trim panel (1) and clip it into the clips (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Feed in the D-pillar trim panel (3) below the sealing lip on the tailgate seal.
Clip in D-pillar trim panel (3) from the clip (5) and from the clamps (4).
Tighten down screws (2).

TIGHTENING TORQUES SPECIFICATION

D-pillar trim panel to support for luggage compartment capping
Sheet metal screw 4.8x16	Tightening torque	2 Nm

Courtesy of BMW OF NORTH AMERICA, INC.