Installing the coolant feed line for the turbocharger
- Replace the O-rings (1).
Parts: O-rings
- Position the coolant feed line (3) at the engine block.
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Coolant feed line to crankcase | ||
| M6 x 12 | Tightening torque | 8 Nm |
- Position the coolant feed line (3) at the turbocharger.
- Tighten down screw (2).
TIGHTENING TORQUES SPECIFICATION
| Coolant feed line/coolant return line to turbocharger | ||
| M6 x 12 | Tightening torque | 8 Nm |
Follow-up work
- Refer to INSTALLING CATALYTIC CONVERTER .
- Refer to INSTALLING EXHAUST SYSTEM .
- Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
- Refer to INSTALLING TANK COVER ON LEFT AND RIGHT .
- Refer to CONNECTING THE COOLANT LINE TO THE RADIATOR .
- Refer to INSTALLING THE FRONT BOTTOM RIGHT WHEEL ARCH COVER .
- Refer to INSTALLING THE OXYGEN SENSOR MONITOR .
- Refer to INSTALLING LAMBDA OXYGEN SENSOR .
- Refer to INSTALLING RESONATOR .
- Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
- Refer to VENTING THE HIGH-TEMPERATURE COOLANT SYSTEM .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .