Installing front brake caliper (high brake)

• Install the brake caliper in the arrow direction.
• Replace screws (1).

  Parts:  Screws

• Tighten down screws (1).
  TIGHTENING TORQUES SPECIFICATIONS
  
  

  Brake caliper/brake anchor plate at front swivel bearing
  M12 Replace screw.	Tightening torque	130 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Fit and tighten brake hose (1)  on brake caliper.

  If necessary, grip at knurling (2).

  TIGHTENING TORQUES SPECIFICATIONS
  
  

  Brake hose to brake caliper, front
  tightening torque	17 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Make sure the brake hose is not  twisted and resting on components attached to the body.
• If necessary, hook the brake hose in the holder (3).

Follow-up work 

• Refer to REMOVING THE BRAKE PEDAL TENSIONER .
• Refer to GREASE BRAKE PADS, BRAKE ANCHOR PLATE AND BRAKE CALIPER WITH BRAKE PAD PASTE .
• Refer to INSTALLING FRONT PADS .
• Refer to INSTALLING THE FRONT BRAKE PAD WEAR SENSOR .
• Refer to INSTALLING FRONT LEFT OR RIGHT WHEEL .
• Refer to FLUSH AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT .
• Refer to COMMISSIONING OR BEDDING IN (BRAKE) OF NEW BRAKE PADS AND DISCS .