Installing the oil pressure switch
- Guide in and install oil pressure switch (2).
- Tighten the oil pressure switch (2) with the special tool 0 496 106 (11 8 720) .
TIGHTENING TORQUE SPECIFICATIONS
| Oil pressure switch to crankcase | ||
| Sensor | tightening torque | 16.5 Nm |
- Connect and lock the connector (1).
The connector (1) must engage audibly.
- Feed in and position the manifold bracket (2).
- Hand-tighten the bolts (1).
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Manifold bracket on intake plenum | ||
| M6x25 | tightening torque | 8 Nm |
- Tighten screws (1) at the manifold brackets (2).
TIGHTENING TORQUE SPECIFICATIONS
| Manifold bracket to crankcase | ||
| M6x16 | tightening torque | 8 Nm |
Follow-up work
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to CHECKING ENGINE OIL LEVEL .