Installing the oil pressure switch
- Guide in and install oil pressure switch (1).
- Tighten the oil pressure switch (1) with the special tool 0 496 106 (11 8 720) .
TIGHTENING TORQUE SPECIFICATIONS
| Oil pressure switch to crankcase | ||
| M12X1.5 | tightening torque | 16.5 Nm |
- Connect connectors (1) and lock.
The connector (1) must engage audibly.
Follow-up work
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to CHECKING ENGINE OIL LEVEL .