Installing the right D-pillar trim panel
NOTE:
Description is for left component only. Procedure on the right side is identical.
Installing D-pillar trim panel
- Check the clamps (1) and clips (3) on the D-pillar trim panel (2) for damage, replace if necessary.
- Fit the D-pillar trim panel (1) and clip it into the clips (2).
- Feed in the D-pillar trim panel (3) below the sealing lip on the tailgate seal.
- Clip in D-pillar trim panel (3) from the clip (5) and from the clamps (4).
- Tighten down screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| D-pillar trim panel to support for luggage compartment capping | ||
| Sheet metal screw 4.8x16 | Tightening torque | 2 Nm |
- Fasten expanding rivet (1).
Follow-up work
- Refer to INSTALLING THE RIGHT C-PILLAR TRIM PANEL .
- Refer to INSTALLING THE LUGGAGE COMPARTMENT TRIM PANEL ON THE RIGHT .
- Refer to INSTALLING LUGGAGE COMPARTMENT LAMP IN RIGHT LUGGAGE COMPARTMENT .
- Refer to INSTALLING THE COVER FOR THE LUGGAGE COMPARTMENT ON THE RIGHT .
- Refer to INSTALLING THE BOTTOM RIGHT D-PILLAR TRIM PANEL .
- Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON RIGHT .
- Refer to INSTALLING RIGHT SEAT BELT FINISHER STRIP COVER .
- Refer to INSTALLING THE FLAP IN THE RIGHT LUGGAGE COMPARTMENT TRIM PANEL .
- Refer to INSTALLING THE FRONT STORAGE SHELF .