Installing the rear emblem
NOTE:
TECHNICAL INFORMATION
Notes on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: NOTES ON COMPONENT BONDING WITH ADHESIVE TAPE .
Notes on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: NOTES ON COMPONENT BONDING WITH ADHESIVE TAPE .
- Replace the emblem.
Parts: Emblem
- Remove the adhesive residues on the body and clean the bonding surface (1).
CONSUMABLE SPECIFICATIONS
| Cleaning agent R2 | 500 ml | 83190417324 |
- Check the guide pins (2).
The guide pins (2) must not be damaged or missing.
- Replace the grommets (3).
Parts: Grommets
- Coat the guide pins (2) using lubricant.
INSTALLATION AID SPECIFICATIONS
| Lubricants G14 | 900 ml, Can | 83232360412 |
- Detach the liner from the adhesive strip of the BMW nameplate.
- Press the badge (1) onto the guide pin (2) and on the adhesive strip.