Installing the rear wheel arch trim
NOTE:
TECHNICAL INFORMATION
To ensure optimal bonding, the bonding surfaces on the inner side of the wheel arch trim panels must not be painted!
You must apply the adhesive pad (two-sided adhesive tape) to the wheel arch trim panel before painting the wheel arch trim panel.
To ensure optimal bonding, the bonding surfaces on the inner side of the wheel arch trim panels must not be painted!
You must apply the adhesive pad (two-sided adhesive tape) to the wheel arch trim panel before painting the wheel arch trim panel.
- Remove adhesive residue.
- Clean the bonding surfaces using cleaning agent R2.
CONSUMABLE SPECIFICATIONS
| Cleaning agent R2 | 500 ml | 83190417324 |
- Adhere to the air drying time of 2 min.
- Pull of the protective film from the adhesive pad (double-sided adhesive tape).
- Position the wheel arch trim (2) and press firmly.
- Refer to Mount blind rivet (1) using the special tool 0 496 521 (00 2 230) .
Follow-up work
- Refer to INSTALLING REAR LEFT OR RIGHT WHEEL .