Installing the cover of the front bumper cover
- Install the cover (1) and snap it in at the detents (2) along the dotted line.
NOTE:
The description is provided only at one component. The procedure is the same for all other components.
- Install the ultrasonic sensors (2) and snap it in at the detents (1).
NOTE:
Perform the steps on the right and left side.
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Air duct to bumper cover | ||
| screw | Tightening torque | 3 Nm |
Follow-up work
- Refer to INSTALLING THE ORNAMENTAL GRILLE ON THE FRONT BUMPER COVER .
- Refer to INSTALLING BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE FRONT SECTIONS OF BOTH WHEEL ARCH COVERS AT THE FRONT .
- Refer to PARTIALLY INSTALLING THE LEFT AND RIGHT FRONT WHEEL ARCH TRIM .
- Refer to INSTALLING FRONT ORNAMENTAL GRILLE .