Installing the clean air pipe for cylinders 1 to 6
- Check seal (1) for damage and, if necessary, replace it.
Parts: Seal
Replacing the damaged seal
NOTE: TECHNICAL INFORMATION
Use of sharp or pointy tools for installation or removal is prohibited.- Remove damaged seal.
- Clean the gasket groove (1) with a dry cloth.
The gasket groove (1) must be clean.
- Replace gasket.
Parts: Seal
Parts: Seal
- Install the seal dry without lubricant or mounting agent.NOTE: TECHNICAL INFORMATION
Incorrect assembly is possible. Ensure correct installation position. - Thread in seal and install.
- Make sure that the seal is installed correctly in the gasket groove (1).
- Make sure that the sealing lip (2) is directed to the inside as shown.
- Detach locks (1) from the holders in the arrow direction.
- Guide in the clean air pipe (2) for cylinders 4 through 6 and install it.
Locks (1) must engage audibly.
- Guide in the clean air pipe (2) for cylinders 1 through 3 and install it.
The locks (1) must engage audibly.
- Connect and lock the connector (1) of the connecting bracket.
The connector (1) must engage audibly.
- Guide in the right air routing (2) in the arrow direction and install it.
The clamps (1) must snap in audibly.