Adjusting the camshafts with the special tool

NOTE: TECHNICAL INFORMATION
Alternative to the new special tool 2 471 127 , the already present special tool 2 456 372 can be used in modified form.
The modified special tool is upward compatible.

Keep set of special tools 2 471 127 at hand:

Number	Description
1	Basic carrier
2	Setting gauge 0.7° for adjusting the intake camshaft
3	Setting gauge 0.5° for adjusting the exhaust camshaft
4	Basic carrier screws on cylinder head
5	Screw gauge on basic carrier

Courtesy of BMW OF NORTH AMERICA, INC.

Use the 0.7° setting gauge (1) from the set of special tools 2 471 127 to adjust intake camshaft .
Use the 0.5° setting gauge (2) from the set of special tools 2 471 127 to adjust exhaust camshaft .

Courtesy of BMW OF NORTH AMERICA, INC.
Position the basic carrier (1) from the set of special tools 2 471 127 on the cylinder head.

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten the screws (1) from set of special tool 2 471 127 on the basic carrier (2) .

TIGHTENING TORQUES SPECIFICATION

Basic carrier to cylinder head
M6	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Rotate the intake camshaft (E) and the exhaust camshaft (A) so that the marks (1) are legible from above.

Courtesy of BMW OF NORTH AMERICA, INC.
Make sure the cam (1) on the exhaust camshaft on cylinder 1 is pointing slightly to the inside right at an angle.

Courtesy of BMW OF NORTH AMERICA, INC.
Make sure the cam (1) on the intake camshaft on cylinder 1 is pointing leftwards at an angle.

Courtesy of BMW OF NORTH AMERICA, INC.
Make sure the flattened areas (1) on the intake camshaft and the exhaust camshaft are pointing upwards at an angle.

Courtesy of BMW OF NORTH AMERICA, INC.
Position the setting gauge 0.5° (2) from the set of special tools 2 471 127 between the exhaust camshaft and the basic carrier (1) from the set of special tools 2 471 127 .
Position the setting gauge 0.7° (3) from the set of special tools 2 471 127 between the intake camshaft and the basic carrier (1) from the set of special tools 2 471 127 .
Tighten down screws (4) .

TIGHTENING TORQUES SPECIFICATION

Test gauge to basic carrier
M6	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.