Removing the coolant feed line part 2 between the auxiliary coolant pump and turbocharger
WARNING:
Hot fluids.
Risk of scalding!
Risk of scalding!
- Conduct all work in the vehicle wearing appropriate personal protective equipment only.
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Preliminary work
- Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to REMOVING THE COVER OF THE REAR RIGHT ENGINE COMPARTMENT .
- Refer to PARTIALLY REMOVING THE MOUNT OF THE HOOD SEAL ON LEFT AND RIGHT .
- Refer to REMOVING SUSPENSION STRUT BRACE .
- Refer to REMOVING INTAKE SILENCER HOUSING .
- Refer to REMOVING MOUNT OF HOOD SEAL ON THE LEFT AND RIGHT .
- Refer to REMOVING THE TOP RIGHT AND LEFT COVER IN THE ENGINE COMPARTMENT .
- Refer to REMOVING THE LEFT AND RIGHT FRONT-END STRUT .
- Refer to REMOVING FRONT CROSS CONNECTION .
- Refer to REMOVING THE REAR TOP CROSS CONNECTION .
- Refer to REMOVING THE RIGHT AIR DUCT .
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION .
- Refer to REMOVING THE CENTER UNDERBODY PROTECTION .
- Refer to REMOVING THE FRONT RIGHT LOWER WHEEL ARCH COVER .
- Refer to DRAINING THE COOLANT FOR THE HIGH-TEMPERATURE COOLANT CIRCUIT .
- Refer to CONNECTING THE COOLANT LINE TO THE RADIATOR .
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
- Unlock lock (1).
- Let the lock (1) engage at the holder (arrow).
- Unlock the locks (1).
- Feed out and remove the clean air pipe (2) for cylinders 1 to 3.
- Unlock the locks (1).
- Feed out and remove the clean air pipe (2) for cylinders 4 to 6.
- Unlock plug connection (1) and disconnect.
- Release lock (arrows).
- Guide out the connector (2) at the carrier plate and set aside.
- Unlock plug connection (3) and disconnect.
- Loosen the lock (4).
- Guide out the connector (5) at the carrier plate and set aside.
- Guide out the cable (1) and (2) along the arrows and set aside.
- Unlock plug connection (1) and disconnect.
- Unlock and release the coolant feed line (1) part 2 at the auxiliary coolant line (2).
- Catch and dispose of leakage coolant.
- Loosen the screws (1) and (2).
- Guide out the coolant feed line (3) part 2 and set aside.
- Catch and dispose of leakage coolant.
- Loosen screw (1).
- Guide out the coolant feed line (2) part 2 and set aside.
- Guide out and remove the coolant feed line (1) part 2 from the clamp (2).