Removing the connecting bracket of the turbocharger for the cylinders 4 to 6

Preliminary work 

• Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
• Refer to REMOVING THE COVER OF THE REAR RIGHT ENGINE COMPARTMENT .
• Refer to PARTIALLY REMOVING THE MOUNT OF THE HOOD SEAL ON LEFT AND RIGHT .
• Refer to REMOVING SUSPENSION STRUT BRACE .
• Refer to REMOVING INTAKE SILENCER HOUSING .

• Unlock the clamps (1).
• Feed out air duct (2) in the arrow direction and remove.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Unlock lock (1).
• Let the lock (1) engage at the holder (arrow).

Courtesy of BMW OF NORTH AMERICA, INC.

• Unlock the locks (1).
• Feed out and remove the clean air pipe (2) for cylinders 4 to 6.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen screws (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Feed out and remove the heat shield (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen screws (1).
• Guide out connecting bracket (2) for cylinders 4 to 6 and remove.

Courtesy of BMW OF NORTH AMERICA, INC.