Install accelerator pedal module
- Connect connectors (1)
and lock.NOTE: RISK OF DAMAGE
Damage to wiring harness
During the assembly of the accelerator pedal module, make sure that the cable is not pinched between the holder and the accelerator pedal module.- Damaged wiring harness must be replaced.
- First, insert accelerator pedal module (1) at the top into the holder (2) in the arrow direction.
- Then, align in the holder (3)
at the bottom.
A positioning pin at the bottom of the accelerator pedal module helps ensure correct alignment.
- Replace the hexagon socket screw (1)
.
Parts: Hexagon socket screw
- Fit the hexagon socket screw (1) and tighten.
TIGHTENING TORQUES SPECIFICATION
| Accelerator pedal module to body | ||
|---|---|---|
| M6 Replace screw. |
tightening torque | 8 Nm |
- Clip in the cover.