Installing the right D-pillar trim panel
NOTE:
Description is for left component only. Procedure on the right side is identical.
Installing D-pillar trim panel
- Check the clamps (1)
and clips (3)
on the D-pillar trim panel (2)
for damage, replace if necessary.
- Fit the D-pillar trim panel (1)
and clip it into the clips (2)
.
- Feed in the D-pillar trim panel (3) below the sealing lip on the tailgate seal.
- Clip in D-pillar trim panel (3) from the clip (5) and from the clamps (4) .
- Tighten down screws (2) .
- Fasten expanding rivet (1) .
Follow-up work
- Refer to INSTALLING THE RIGHT C-PILLAR TRIM PANEL .
- Refer to INSTALLING THE LUGGAGE COMPARTMENT TRIM PANEL ON THE RIGHT .
- Refer to INSTALLING LUGGAGE COMPARTMENT LAMP IN RIGHT LUGGAGE COMPARTMENT .
- Refer to INSTALLING THE COVER FOR THE LUGGAGE COMPARTMENT ON THE RIGHT .
- Refer to INSTALLING THE BOTTOM RIGHT D-PILLAR TRIM PANEL .
- Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON RIGHT .
- Refer to INSTALLING RIGHT SEAT BELT FINISHER STRIP COVER .
- Refer to INSTALLING THE FLAP IN THE RIGHT LUGGAGE COMPARTMENT TRIM PANEL .
- Refer to INSTALLING THE FRONT STORAGE SHELF .