Installing the guide for the rear bumper panel at the side
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Correctly position the guide for the rear bumper panel at the side (3) .
- Tighten nuts (1) .
TIGHTENING TORQUES SPECIFICATION
| Bumper guide to body | ||
|---|---|---|
| Nut | Tightening torque | 4.6 Nm |
- Tighten down screw (2) .
TIGHTENING TORQUES SPECIFICATION
| Bumper panel, rear | ||
|---|---|---|
| Hexagon screw | Tightening torque | 2.5 Nm |
- Tighten the screws (1) .
TIGHTENING TORQUES SPECIFICATION
| Bumper panel, rear | ||
|---|---|---|
| Hexagon screw | Tightening torque | 2.5 Nm |