Installing coolant pump with support

• Check the fitting sleeves (1) for damage, replace if necessary (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: TECHNICAL INFORMATION 
  The sealing surfaces must be free of oil, grease and cleaning agents.
• Clean sealing surface (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace gasket (1).

  Parts:  Gasket

• Replace O-ring on the heat management module.

Parts:  O-ring

Courtesy of BMW OF NORTH AMERICA, INC.

• Position the coolant pump (2) with support on the fitting sleeves.
• Tighten down screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (2).

• Connect vacuum hose (1) and attach to the clamp.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to CONNECTING THE COOLANT LINE TO THE RADIATOR .
• Refer to INSTALLING AIR CONDITIONING COMPRESSOR .
• Refer to INSTALLING THE ALTERNATOR .
• Refer to INSTALLING THE DRIVE BELT FOR ALTERNATOR .
• Refer to PREPARING THE THROTTLE BODY .
• Refer to INSTALLING THE THROTTLE BODY .
• Refer to INSTALLING FAN COWL .
• Refer to INSTALLING CHARGE AIR LINE .
• Refer to INSTALLING RESONATOR .
• Refer to INSTALLING INTAKE FILTER HOUSING .
• Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
• Refer to INSTALLING FRONT CROSS CONNECTION .
• Refer to INSTALLING FRONT-END STRUT ON LEFT AND RIGHT .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
• Refer to VENTING THE HIGH-TEMPERATURE COOLANT SYSTEM .
• Refer to INSTALLING THE FRONT BOTTOM RIGHT WHEEL ARCH COVER .
• Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
• Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
• Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .
• Refer to RECONNECTING ALL BATTERY GROUND LEADS .
• Refer to EVACUATE AND CHARGE CONDITIONING .