Replacing the intake plenum
- Loosen screw (1).
- Remove the boost pressure sensor (2).
- Guide out and remove holder (3).
- Loosen clamp (1).
- Loosen clamp (1).
- Remove screws (arrows).
- Remove the throttle bodies (1).
- Replace sealing ring (1).
Parts: Sealing ring
- Replace sealing ring (1).
Parts: Sealing ring
- Feed in and install the throttle body (1).
- Tighten screws (arrows).
TIGHTENING TORQUES SPECIFICATION
| Throttle body to intake plenum | ||
| M6X50 | Tightening torque | 7 Nm |
- Check sealing ring (1) for damage and, if necessary, replace it.
Parts: Sealing ring
- Apply a thin coat of lubricant to the sealing ring (1) of the boost pressure sensor.
- Insert and install the holder (3).
- Insert and install the boost pressure sensor (2).
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Boost pressure sensor to intake plenum | ||
| TS6X20 | Tightening torque | 5 Nm |