Installing front brake caliper (18-inch high brake)

• Install the brake caliper in the arrow direction.
• Replace screws (1).

  Parts:  Screws

• Tighten down screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Brake caliper/brake anchor plate at front swivel bearing
  M12 Replace screw.	Tightening torque	110 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Fit and tighten brake hose (1) on brake caliper.

  If necessary, grip at knurling (2).

  TIGHTENING TORQUES SPECIFICATION
  
  

  Brake hose to brake caliper, front
  	Tightening torque	17 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Make sure the brake hose is not  twisted and resting on components attached to the body.
• If necessary, hook the brake hose in the holder (3).

Follow-up work 

• Remove the brake pedal TENSIONER .
• Grease brake pads, brake anchor plate and brake caliper with brake PAD PASTE  (18-inch high brake).
• Install FRONT PADS  (18-inch high brake).
• Install the front brake pad WEAR SENSOR .
• Install front left or right WHEEL .
• FLUSH AND BLEED  the front axle brake circuit (18-inch high brake).
• COMMISSION OR BED (BREAK) IN of new brake pads and discs (18-inch high brake).