Removing transmission oil cooler
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
Preliminary work
- Remove the front UNDERBODY PROTECTION .
- Remove the center UNDERBODY PROTECTION .
- Remove rear UNDERBODY PROTECTION .
- Remove the front right lower wheel arch COVER .
- Drain the high-temperature coolant circuit COOLANT .
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
- Unlock and loosen coolant line (1).
- Catch and dispose of escaping coolant.
- Unlock and loosen coolant line (2).
- Catch and dispose of escaping coolant.
- Unlock the locks (1) on the transmission oil lines (2) in the arrow direction.
- Disconnect the transmission oil lines (2).
- Collect and dispose of emerging fluids.
- Loosen clamp (1).
- Loosen screws (2).
- Loosen screw (3).
- Release the screw (2).
- Guide out and remove the transmission oil cooler (1).