Install charge air line

Replace the sealing ring (1) on the throttle valve.
Parts: Sealing ring

Courtesy of BMW OF NORTH AMERICA, INC.
Check the sealing ring (1) on the charge air line for damage and replace, if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.

Replacing the damaged seal

NOTE: TECHNICAL INFORMATION
Use of sharp or pointy tools for installation or removal is prohibited.

Remove damaged seal.
Clean the gasket groove (1) with a dry cloth.
The gasket groove (1) must be clean.

Courtesy of BMW OF NORTH AMERICA, INC.
Replace gasket.
Parts: Gasket
Install the seal dry without lubricant or mounting agent.
NOTE: TECHNICAL INFORMATION
Incorrect assembly is possible. Ensure correct installation position.

Courtesy of BMW OF NORTH AMERICA, INC.
Thread in seal and install.
Make sure that the seal is installed correctly in the gasket groove (1).
Make sure that the sealing lip (2) is directed to the inside as shown.

Insert and install charge air line (5).
Lock the clamp (4) on the exhaust turbocharger.
The clamp (4) must engage audibly.

Tighten screws (arrows).

TIGHTENING TORQUES SPECIFICATION

Charge air line to throttle body
M6	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect and lock connector (3) on the charge-air temperature sensor.
Connect and lock connector (1) on the boost pressure sensor.
All connectors must audibly engage.
Secure clamps (2).

Follow-up work