Remove clean air pipe
WARNING:
High-voltage system.
The high-voltage system operates on the basis of hazardous, electrical voltage and high currents. Mortal hazard through electric shock!
The high-voltage system operates on the basis of hazardous, electrical voltage and high currents. Mortal hazard through electric shock!
- All work on the high-voltage system may only be carried out by specially trained and technically experienced personnel.
- For additional information see: SAFETY INSTRUCTIONS ON HANDLING HYBRID CARS .
- For additional information see: NOTES ON REPAIR OF HIGH-VOLTAGE BATTERY UNIT .
Preliminary work
- Remove the ACOUSTIC COVER .
- Remove RESONATOR .
- Version A: NOTE: The following step(s) must be performed if the listed component(s) is/are installed.
- Loosen clamp (1).
- Unlock plug connection (1) and disconnect.
- Unlock lock (2).
- Feed the engine ventilation line (3) out and set it aside.
- Unfasten clamp (4).
- Feed out the clean air pipe (5) upwards and put it aside.
- Unlock lock (1).
- Guide the line (2) out and set it aside.
- Unlock lock (3).
- Guide the line (4) out and set it aside.
- Unlock the clamp (1).
- Feed out clean air pipe and remove (2).
- Version B:
- Unlock the locks (1).
- Detach the engine ventilation line (2).
- Unlock plug connection (1) and disconnect.
- Unlock and detach the line (2).
- Loosen clamp (3).
- Loosen clamp (4).
- Feed out the clean air pipe (5) upwards and put it aside.
- Unlock the clamp (1).
- Feed out the clean air pipe (2) and remove.