Move the engine to the installation position
Preliminary work
- Remove the ACOUSTIC COVER .
- Bring front compartment lid in the SERVICE POSITION .
- Remove the rear left engine compartment COVER .
- Remove the rear right engine compartment COVER .
- Remove the top right and left engine compartment COVER .
- Remove left and right hood gasket STAND .
- Remove the center UNDERBODY PROTECTION .
- Remove rear UNDERBODY PROTECTION .
Install the engine bridge
Prepared engine bridge
Prepared engine bridge
CAUTION:
Components connected to the engine joint or cross member.
Injury hazard!
Injury hazard!
- Check lifting eyes and engine mounting brackets for damage, e.g. cracks.
- Attach the component to correctly mounted engine joints or cross members only.
- Only lift the component, do not shift it forwards, backwards or in transverse direction.
NOTE:
TECHNICAL INFORMATION
Conduct the following operation with the assistance of a second person.
Conduct the following operation with the assistance of a second person.
- Carefully position engine bridge (1) with help from an assistant.
- Make sure that the special tool 0 496 438 (00 6 053) from the special tool kit 0 496 430 (00 6 050) rests correctly on the hood lock support on the left.
- Make sure that the special tool 0 496 437 (00 6 052)
from the set of special tools 0 496 430 (00 6 050)
rests correctly on the spring bolt on the left.
- Make sure that the special tool 0 496 438 (00 6 053) from the special tool kit 0 496 430 (00 6 050) rests correctly on the hood lock support on the right.
- Make sure that the special tool 0 496 437 (00 6 052)
from the set of special tools 0 496 430 (00 6 050)
rests correctly on the spring bolt on the right.
- If necessary, release the nuts (1) and position the engine bridge (2).
- Attach the hook (1) in the mounting bracket on the cylinder head.
- Lift the engine by 10 mm by turning the spindle 2 361 506 (00 6 103) .