Removing the vibration damper

WARNING: Working on 12 V electrical system.
Risk of short circuits! Risk of fire!

Make sure that there is no charger connected to the jump start terminal in the engine compartment.
Detach battery ground lead from battery.
For auxiliary batteries: Detach battery minus cables from all auxiliary batteries.

NOTE: RISK OF DAMAGE
Damage to battery terminal, the safety battery terminal or the intelligent battery sensor (IBS).
Damaged battery terminals can lead to malfunctions or vehicle electrical system faults.

Detach battery terminal from battery pole Do not pry off using a tool.

NOTE: TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.

Preliminary work

Disconnect all battery GROUND LEADS .
Remove the ACOUSTIC COVER .
Remove RESONATOR .
Remove clean AIR PIPE .
Remove charge AIR LINE .
Remove the engine front ACOUSTIC COVER .
Remove the alternator DRIVE BELT .
Remove the center UNDERBODY PROTECTION .
Remove rear UNDERBODY PROTECTION .
Remove STARTER MOTOR .

Position the special tool 0 496 595 (11 6 130) and secure it on the timing case cover using the bolt (1).
The special tool 0 496 595 (11 6 130) must lie flat on the transmission housing.
If necessary, turn the engine in the direction of rotation until the teeth (3) engage completely in the gearing of the flywheel (4).
Slide the counter support with the screw (2) upwards in the arrow direction until the teeth (3) engage completely in the gearing of the flywheel.

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten down screw (2).
Use a screwdriver to unscrew the cover (1) from the vibration damper.

Courtesy of BMW OF NORTH AMERICA, INC.
Unscrew the bolts (arrows) on the vibration damper (1).
Remove the vibration damper (1).

Courtesy of BMW OF NORTH AMERICA, INC.