Install tension strut on shock tower
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Install tension strut (3) on the shock tower.
- Replace the screw (1).
Parts: Screw
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Tension strut on firewall | ||
| M10x25 screw Replace screw. |
Joining torque | 56 Nm |
| Angle of rotation | 90° | |
- Replace the screw (2).
Parts: Screw
- Tighten down screw (2).
TIGHTENING TORQUES SPECIFICATION
| Tension strut to shock tower | ||
| Torx bolt Replace screw. |
Joining torque | 56 Nm |
| Angle of rotation | 90° | |
→ Repair thread on the spring bolt
- Repair the damaged thread with a Helicoil thread insert.
CONSUMABLE DESCRIPTION
| Helicoil thread insert | M10x25 mm | 33 30 6 782 756 |
Follow-up work