Installing windshield.
- Prepare the glue cartridge with the standard nozzle C.
- Apply bead joint in area (1).
- Apply adhesive bead within the mark on the windshield.
| Cut | A - A | B - B | C - C |
|---|---|---|---|
| a = Position of the adhesive bead | 2 ±2 mm | 3 ±2 mm | 2 ±2 mm |
| b = Width of adhesive bead | 8 ±1 mm | 8 ±1 mm | 8 ±1 mm |
| h = Height of adhesive bead | 12 ±1 mm | 12 ±1 mm | 12 ±1 mm |
- Adhere to the geometry of the adhesive bead to make sure that one glue cartridge is sufficient for the complete windshield.
- Carefully perform the following operations on the windshield (1) with suction lifter:
- Running it in parallel to the A-pillar
- Feed it in the area (A) on left and right below the side panel
- Position at top
- Align sides evenly
- Press upwards until seal rests evenly on roof
- Press evenly all around
- Fix with adhesive tape on the roof
- Measure the recessed (A) of the windshield (1) to the roof outer skin (2) with the special tool 0 495 259 (51 0 010) .
- Adjust the recessed (A).
TECHNICAL DATA SPECIFICATION
| Gap dimension windshield to roof outer skin | |
| 1 windshield; 2 roof outer skin | a
4.3 +1-1
mm b 2.5 +1.5-1.5 mm |
- Position the windshield (1) in such a way that the rubber frame (3) lies even and parallel to the roof outer skin (2).NOTE: Perform the steps on the right and left side.
- Mount the cover (1) and attach it to the guide (3).
- Engage the cover (1) at the clip (2).
Follow-up work
- Connect rain-light-solar-condensation sensor CONNECTOR .
- Install the KAFAS camera with the integrated CONTROL UNIT .
- Install the interior REARVIEW MIRROR .
- Install the interior rearview mirror COVERS .
- Install a-pillar TRIM PANEL .
- Install windshield panel COVER .
- Install left and right WIPER ARM .
- Install the rear right engine compartment COVER .
- Install the rear left engine compartment COVER .
- Install windshield GUTTER STRIP .
- Calibrate KAFAS CAMERA .