Installing transmission cross member.
- Install transmission cross-member.
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Transmission cross member to rubber mounts | ||
|---|---|---|
| M12 | tightening torque | 68 Nm |
- Tighten down screws (2).
TIGHTENING TORQUES SPECIFICATION
| Transmission cross member to body | ||
|---|---|---|
| M8 | tightening torque | 19 Nm |
- Remove the transmission jack.
Follow-up work
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .