Bringing the engine to the installation position (6-cyl.)

Installing the engine bridge:

Prepared engine bridge:

Courtesy of BMW OF NORTH AMERICA, INC.

Prepared engine bridge

CAUTION: Components connected to the engine joint or cross member.
Injury hazard!

Check lifting eyes and engine mounting brackets for damage, e.g. cracks.
Attach the component to correctly mounted engine joints or cross members only.
Only lift the component, do not shift it forwards, backwards or in transverse direction.

Equipment specification without front mounting bracket:
Insert and position the special tool 2 459 012 at the cylinder head.

Tighten the screws (1) of the special tool 2 459 012 .

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
Conduct the following operation with the assistance of a second person.
Carefully position engine bridge (1) with help from an assistant.

Courtesy of BMW OF NORTH AMERICA, INC.
Ensure that the special tool 0 496 438 (00 6 053) from the special tool kit 0 496 430 (00 6 050) on the left rests correctly on the fixture for the bonnet lock.
Ensure that the special tool 0 496 437 (00 6 052) from the special tool kit 0 496 430 (00 6 050) on the left rests correctly on the spring strut dome.

Courtesy of BMW OF NORTH AMERICA, INC.
Ensure that the special tool 0 496 438 (00 6 053) from the special tool kit 0 496 430 (00 6 050) on the right rests correctly on the fixture for the bonnet lock.
Ensure that the special tool 0 496 437 (00 6 052) from the special tool kit 0 496 430 (00 6 050) on the right rests correctly on the spring strut dome.

Courtesy of BMW OF NORTH AMERICA, INC.
If necessary, release the nuts (1) and position the engine bridge (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Fit the special tool 0 490 579 (11 0 070) to the engine bridge.
Attach the special tool 0 490 579 (11 0 070) in the mounting bracket (1) at rear on the cylinder head.
Fit the special tool 0 490 579 (11 0 070) in the front mounting bracket (2) on the cylinder head.

Courtesy of BMW OF NORTH AMERICA, INC.

Releasing the engine support brackets on the left and right engine mounts:

Unscrew screw (1) on right engine support bracket from the bottom.

Courtesy of BMW OF NORTH AMERICA, INC.
Prepare special tool 0 493 751 (11 9 150) as shown.

Courtesy of BMW OF NORTH AMERICA, INC.
Release the screw (1) on the left engine support bracket from the bottom using the special tool 0 493 751 (11 9 150) .

Courtesy of BMW OF NORTH AMERICA, INC.

Lift the engine by 10 mm by turning the spindle 2 361 506 (00 6 103) .

Courtesy of BMW OF NORTH AMERICA, INC.