Install front engine encapsulation
- Install the engine encapsulation (1).
- Correctly route the wiring harness (3) and clip it in at the highlighted areas.
- If necessary, position the ground cable and secure it with the screw.
TIGHTENING TORQUES SPECIFICATION
| Front ground cable to cylinder head | ||
|---|---|---|
| M6 | tightening torque | 8 Nm |
- Connect connectors (1) and (2).
NOTE:
TECHNICAL INFORMATION
Make sure that the connections are locked correctly. The locks must engage audibly.
Make sure that the connections are locked correctly. The locks must engage audibly.
- Connect the ventilation line (2) with the intake plenum.
- Connect the ventilation line (1) with the tank vent valve and clip it in at the highlighted area.
Follow-up work
- Refer to INSTALLING CLEAN AIR PIPE, TOP .
- Refer to INSTALLING INTAKE FILTER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .