Installing the oil coolant heat exchanger
NOTE:
RISK OF DAMAGE
Damage to the surface.
The use of metal-cutting tools (e.g., emery cloths) for cleaning surfaces can damage them and lead to leaks and/or engine damage.
Damage to the surface.
The use of metal-cutting tools (e.g., emery cloths) for cleaning surfaces can damage them and lead to leaks and/or engine damage.
- Do not use any metal-cutting tools.
- Clean sealing surface (1).
- Replace gaskets (1), (2), (3) and (4).
Parts: Seals
- Position the oil coolant heat exchanger on the full-flow oil filter.
- Tighten the screws (1), (2), (3), (4), (5) and (6).
TIGHTENING TORQUES SPECIFICATION
| Oil-to-water heat exchanger to full-flow oil filter | ||
| M6 | tightening torque | 10 Nm |
- Tighten the lid on the full-flow oil filter.
TIGHTENING TORQUES SPECIFICATION
| Oil filter cover to oil filter module | ||
| O-ring lightly oiled. | Tightening torque | 25 Nm |
Follow-up work
- Refer to TIGHTENING THE OIL FILTER CAP .
- Refer to TOPPING UP THE MOTOR OIL .
- Refer to INSTALLING THE OIL FILLER CAP .
- Refer to INSTALLING THE TRANSMISSION OIL COOLER .
- Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
- Refer to VENTING THE HIGH-TEMPERATURE COOLANT SYSTEM .
- Refer to CHECKING ENGINE OIL LEVEL .
- Refer to CHECKING/TOPPING UP THE OIL LEVEL IN THE AUTOMATIC TRANSMISSION .
- Refer to INSTALLING THE FRONT BOTTOM RIGHT WHEEL ARCH COVER .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to TAKING HOOD OUT OF THE SERVICE POSITION .