Installing exhaust turbocharger

• Replace gasket.

  Parts:  Seals

• When installing the seal, make sure the part number (1) remains legible.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Mount gasket (1).
• Make sure the seal (1) is correctly installed on the guide pins.
• If necessary, have the seal (1) affixed by a support person.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert the exhaust turbocharger (1) and position it on the trim strip.
• Protect the exhaust turbocharger (1) from falling.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Mount the reinforcement plate (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace nuts (1) to (5).

  Parts:  Nuts

• Tighten the nuts in sequence (1) to (5).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Exhaust manifold to cylinder head
  Flange nut M7 Replace nuts.	1. Joining torque	10 Nm
  	2. Joining torque	10 Nm
  	3. Joining torque	16 Nm
  	4. Tightening torque	16 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Check for correct installation of the seal on the guide pins between the exhaust manifold and the cylinder head.
• If necessary, connect the connector (1) to the exhaust turbocharger and lock.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the heat shield (4).
• Tighten down screws (3).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Heat shield to cylinder head
  M8 x 12	Tightening torque	19 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Attach heat shield (2) in marked area.
• Tighten down screw (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Heat shield to cylinder head
  M8 x 12	Tightening torque	19 Nm

• Tighten the bolt (1) on the heat shield (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE OIL FEED LINE FOR THE EXHAUST TURBOCHARGER .
• Refer to ATTACH THE OIL RETURN LINE FOR THE EXHAUST TURBOCHARGER .
• Refer to INSTALLING THE COOLANT RETURN LINE FOR THE EXHAUST TURBOCHARGER .
• Refer to INSTALLING COOLANT FEED LINE FOR EXHAUST TURBOCHARGER .
• Refer to INSTALLING CATALYTIC CONVERTER .
• Refer to INSTALLING EXHAUST SYSTEM .
• Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
• Refer to INSTALLING TANK COVER ON LEFT AND RIGHT .
• Refer to CONNECTING THE COOLANT LINE TO THE RADIATOR .
• Refer to INSTALLING THE FRONT BOTTOM RIGHT WHEEL ARCH COVER .
• Refer to INSTALLING THE OXYGEN SENSOR MONITOR .
• Refer to INSTALLING LAMBDA OXYGEN SENSOR .
• Refer to INSTALLING CHARGE AIR LINE .
• Refer to INSTALLING CLEAN AIR PIPE .
• Refer to INSTALLING RESONATOR .
• Refer to FILL THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
• Refer to VENT THE HIGH-TEMPERATURE COOLANT SYSTEM .
• Refer to CHECK ENGINE OIL LEVEL .
• Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
• Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to TAKE HOOD OUT OF THE SERVICE POSITION .