Removing the electric vacuum pump
DANGER
High-voltage system.
The high-voltage system operates on the basis of hazardous, electrical voltage and high currents. Mortal hazard through electric shock!
- All work on the high-voltage system may only be carried out by specially trained and technically experienced personnel.
- For additional information see: SAFETY INSTRUCTIONS ON HANDLING HYBRID CARS .
- For additional information see: NOTES ON REPAIR OF HIGH-VOLTAGE BATTERY UNIT .
WARNING:
Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Observe safety instructions on raising the vehicle using a vehicle hoist.
- For additional information see: 00... Raise the vehicle using a VEHICLE LIFT. .
Preliminary work
- Remove the front UNDERBODY PROTECTION .
- Remove the center UNDERBODY PROTECTION .
- Unlock plug connection (1) and disconnect.
- Unlock the connector housing (2) and remove it from holder.
- Unlock and detach the snap fastener (1).
- Loosen screw (2).
- Remove the electrical vacuum pump (1) in an upwards direction.